Optional short row bust shaping: the directions instruct you to work two rows to pick up all wraps, which would leave a couple of holes on either side of the shaped area. Instead, after wrapping 4 sts on each side (8 rows), work 1 rnd (you should be on the RS), picking up all wraps and knitting them tog with wrapped sts. Rep entire short row section once for D cup and twice for DD cup. Because you add a rnd for each set of short rows worked (when you pick up the wrapped sts), subtract 1 (2, 3) rnds for C (D, DD) cup from # of rnds in next section (after completion of short rows and before dividing for front and back).
Patterns purchased after January 5th, 2010 include this correction as well as corrections below. Patterns after March 11th, 2008 but before 1/5/10 include only the corrections listed below.
The first row of armhole shaping instructions is actually put under the heading "FRONT". The first sentence after "FRONT" should read "...k to 5 (NOT 3) sts before right side marker, ssk, SSE". Under "Armhole shaping" (subheading of "FRONT"), the number of times to repeat the two armhole shaping rows is INCORRECT for some sizes: please substitute the following: Rep these 2 rows 0 (0, 1, 2, 3, 4, 6) times. Same paragraph: number of rows to work even after armhole shaping is incorrect for some sizes: should be 8 (10, 8, 8, 6, 6, 4) rows.
Under BACK: After joining yarn to work RS, begin armhole shaping to correspond to Front immediately; do not knit one row first.
If you purchased this pattern before any or all of the above corrections were made, and would like a corrected copy, please email me at [email protected].
Comments